By Trish from Green Lane, PA on December 3, 2012
What is the CFM output?
By Collin C. - NFI Master Hearth Professional on December 4, 2012
Answer:This blower's cubic feet per minute (CFM) output is approximately 165.
By Jeff Brarunstein from Portland, OR on January 6, 2013
I have a NG gas fireplace log set. The pilot is always on and the flame is manually adjusted with a dial. I would like this set to have a wall switch, remote, or both to turn on the flame to a set size (does not need to be variable). I would also like a fan to blow the warm air into the room. This set is installed into a masonry fireplace but is not vented. Do product exists for what I have described above?
By Collin C. - NFI Master Hearth Professional on January 7, 2013
Answer:When dealing with a vent-free set in a masonry fireplace, your options will be limited. There is no blower that can be used with a vent-free log set when used in a masonry fireplace.
Unless the fireplace has a built-in housing to accept a blower, there is not a way to retrofit one. As for remote control of the unit, this will depend on the gas valve.
By David from Reno, NV on January 25, 2013
Where is a good place to plug in the green ground wire for the fan assembly?
By Collin C. - NFI Master Hearth Professional on January 25, 2013
Answer:While most fan assemblies have a ground wire that is incorporated into the wiring harness, others have a separate wire that must be grounded to the chassis of the unit. If this is the case, it can be grounded to any available fastener in the underside of the fireplace. Some units will even have a screw labeled for grounding that the valve or other electronic components will use.
By Ronald from Oregon on October 21, 2013
What are the RPM's of this unit? Also what is the size of the air out flow opening?
By Collin C. - NFI Master Hearth Professional on October 24, 2013
Answer:Per the manufacturer, this fan has a maximum RPM of 2,500. The air output deflector measures 10 1/4 inches wide, 3 1/4 inches tall, and 4 1/2 inches wide.