By Richard from Bathhurst, New Brunswick on January 15, 2013
I just purchased this product for my eco 45 pellet stove. The stove starts but I can't get the temp control to work. How do I wire it in?
By Collin C. - NFI Master Hearth Professional on January 15, 2013
Answer:This thermostat requires that you route the low voltage wires to the switch block on the right rear side of the stove (as you face it). There are a pair of small phillips head screws on the rear of the stove that make up the switch block. The low voltage wires must be inserted into the hold downs, then re-tighten the screws. The thermostat will perform best when it is more than 15 feet away from the stove.