Part Number: 7DT-RS eFireplaceStore Item Number: CPF-70760 UPC: 662492869208 Features
*Venting Requirements: This unit requires venting pipe with an inner diameter of 7 Inches. Please see the Venting Components section on this page if available for venting pipe that must be used with this unit. * Please Note: Trim Collar must be purchased separately. Are you completing the installation of a DuraTech chimney system for your new appliance? This all-fuel chimney roof support kit provides the structural reinforcement necessary when directing a DuraTech chimney through a roof. The handy venting accessory adjusts to different roof pitches and is designed for use with 7" DuraTech chimney pipes. It can support up to 45' of pipe above and 20' of chimney below, and it comes with a limited lifetime warranty. The system is tested for use with any 2100 degrees Fahrenheit chimney system. Chimney Pipe Buyers Guide How Flex Venting Helps Complicated Vent Pipe Set Up The Basics Of The Fireplace Flue DuraVent Type B Venting Installation Guide DirectVent Pro Installation Guide Duratech Chimney Pipe Installation Guide DuraPlus Chimney Pipe Installation Guide Chimney Pipe Buying Guide Pellet Vent Pro Installation Guide Chimney Cap Buying Guide |