Part Number: 21076
eFireplaceStore Item Number: CPF-21076
*Venting Requirements: This unit requires venting pipe with an inner diameter of 7 Inches. Please see the Venting Components section on this page if available for venting pipe that must be used with this unit.
* Please Note: HomeSaver can only be sold and shipped to general contractors or licensed chimney sweeps. Orders to the general public cannot be fulfilled. If you have a contractor please provide his name and address. This will need to be shipped directly to the contractor. The manufacturer will not make exceptions.
This connector adaptor is necessary when you are mating RoundFlex pipe on top to a rigid pipe below, RoundFlex to RoundFlex, or RoundFlex to another type of HomeSaver Flex pipe with an adaptor. It allows the necessary 'male-end down' joint in the installation of the chimney liner. It has a diameter of 7", and connects using rivets (rivets not included). Note that a connector/adaptor is unnecessary when connect rigid pipe on top to flex pipe on bottom.