Free shipping
Low Price
secure-order
View Cart

    Dura-Vent DirectVent Pro Snorkel Vent Termination Cap - For Vent Pipes with a 4-Inch Inner Diameter - 46DVA-SNK14

    509.77
    List Price: $629.99
    Sale Price: $509.77
    You Save: $120.22 (19%)
    In Stock.
    * Usually Ships Same Business Day.
    See complete product details >>
    Product Details
    Free Venting Design & Quote:
    Manufacturer: DuraVent
    Part Numbers: 46DVA-SNK36, 46DVA-SNK14
    eFireplaceStore Item Number: CPF-694-DVPSNORK
    UPCs: 662492470497, 662492594896

    Features

    • Allows direct vent system to meet minimum height requirements
    • For use with horizontal  through-wall terminations
    • Compatible with DirectVent Pro venting products
    • Two sizes available
    • Limited lifetime warranty
      • Dimensions:

        • 14":
          • 6 5/8" opening
          • 14" H x 9" W
        • 36":
          • 6 5/8" opening
          • 36" H x 9" W


    *Venting Requirements: This unit requires venting pipe with an inner diameter of 4 Inches. Please see the Venting Components section on this page for venting pipe that must be used with this unit.

    If your ventilation installation requires a minimum vent height, this DirectVent Pro Snorkel vent termination cap will provide that additional height. Manufactured by Dura-Vent this termination cap allows direct vent systems to meet minimum height requirements while providing a unitized, coaxial venting system that is designed for use with direct vent gas or propane heaters and fireplaces. Made with .020 in. aluminum inner wall, and .018 in. galvanized steel outer wall, this termination cap is compatible with DirectVent Pro venting products and is available in 2 sizes.
    Customer Questions & Answers
    2 Questions & 2 Answers
    stan
    from Oxnard, CA asked:
    October 18, 2012
    Can this snorkel replace 18' of exterior verticle oval vent for a Williams 75000 wall heater with a 90 degree straight exhaustion pipe of 9' from the furnace?
    1 Answers
    Typically, this snorkel is only meant to elevate the termination of a direct vent fireplace or furnace that is installed below grade.
    Collin C. - NFI Master Hearth Professional
    on October 18, 2012

    Ryan
    from Parkersburg, IA asked:
    September 3, 2012
    Does the snorkel vent need to be installed on the wood wall and siding around it, or can it be used over the top of existing siding with a universal thimble where it goes through the wall and hi-temp caulk to seal it all up?
    1 Answers
    Ideally, the snorkel would be installed on the unsided wall, then siding would be installed up against either side of the snorkel housing. However, it is perfectly acceptable to install the snorkel on top of wood siding. As you mention, it will be necessary to seal around the thimble flashing, as it will not lay flat against the angled siding slats.
    Collin C. - NFI Master Hearth Professional
    on September 4, 2012

    Customer Reviews
    test
    +

    Let Our Experts Design
    Your Venting System

    +

    Find the Right Gas Logs
    For Your Fireplace

    Sign-up for our Email!
    Enter your email for new arrivals and special offers.