Superior SecureVent Horizontal Termination Kit HT2 with 90 Degree Elbow

Great product and shipping was fast

I had some problems with the 90 degree elbow tightening on the 3 foot extension it seemed to be larger than the pipe. I used number 10 self taping screws to make sure the pipe was secure.The hood is very large and I think designed for new construction. Since I was mounting this partly on a concrete wall and partly on vinyl siding I had some elevation differences. On the siding 2 inches of Styrofoam rigid insulation was put on before the siding and where it met with the concrete it was indented another 2 inches. Since the hood only has an 1 1/4 inch lip I had a problem. You can not mount the hood any lower into the wall than 1 1/4 inches. After speaking with the Efireplace experts and getting approval from the gas inspector I was able to make a 4 1/2 in extension to pop rivet into the 1 1/4 flange. Then using tin snips I was able to cut this new shroud to perfectly match the contours of the building. It looks quite good.It hasn't been inspected yet so hears hoping. I would be nice if they could come up with a better design. This hood is big, bulky, flimsy and expensive.

Could have been packaged a little better. Came slightly bent but not enough to impact the install.

This is a great product and the customer service I have been receiving from Tyler has been even better! He's always available to answer even the smallest questions I have!

All positive