Part Number: WRT2036WSI
eFireplaceStore Item Number: SUP-WRT2036WSI
*Venting Requirements: This unit requires venting pipe with an inner diameter of 8 Inches. Please see the Venting Components section on this page if available for venting pipe that must be used with this unit.
* Please Note: Fully insulated fireboxes feature an additional layer of ceramic insulation, as well as the standard air space. They are recommended for installations against an outside wall or in an exterior chase enclosure, as they provide superior protection against cold air intrusion into the room when the fireplace is not in use.
*Also Note: This model is a direct replacement to the previously available Vantage Hearth Value Line Series 36" Non-Circulating Smooth Faced Wood Burning Fireplace with Full Insulation VB36I1.
Even with all the options for gas fireplaces, some people prefer the coziness, warmth, and soothing sounds of a wood-burning fireplace. If you are one of those people, Superior has perfected the beautiful and economic wood-burning fireplaces in their WRT/WCT2036 Merit Series. These give a "big box" look and have an oversize brick to brick opening. You can choose between clean-face and circulating models. Both come with a full, smooth white refractory panel, textured powder coat finish, and mesh fire screens. To make it easier to install, both are equipped with 8" pipes. Fan kits are also available for circulating models only.
Fireplace Fireboxes (Buyers Guide)
Superior (Buyers Guide)
Wood Burning Fireplaces (Buyers Guide)
Zero Clearance Fireplaces (Buyers Guide)
The Basics Of The Fireplace Flue
Wood Ash: The Benefits You Never Knew
California Title 24: Complete Guide To Net Zero Energy
What Is The Difference Between Wood Stove Coverage And Efficiency?
The Fireplace Hearth Then and Now
Fireplace Installation Checklist (for All 9 Stages)
Can this be used with doors from another manufacturer?
Yes, however, the manual states: This fireplace is approved for use as a wood burning fireplace or for use with a vented gas log approved to ANSI Z21.60 or Z21.84 standards or for use with a vent-free gas log heater approved to ANSI Z21.11.2 standard. An IHP hood must be installed when using a vent-free log heater
The 2/10 regulation is separate. It states that the termination point must be at LEAST 2 feet high then ANYTHING within a 10-foot radius (this includes the roof itself). These are two separate but equally important codes.