By Dan from NH on January 26, 2015
I have a Jotul F 3 USA stove that I am trying to fit into an existing fireplace. I am looking at your products and am not sure of the best way to make the installation.
I have a 6" pipe coupling exiting the rear of the stove and I think I have enough room to put in an elbow before I go vertical. Because I have less than 6" in the full open position of the flue damper I was thinking of installing your Ventinox connector sealing kit into the damper and extending it around to the oval pipe from my stove to about 3' up into the chimney. Can you suggest the proper fitting and components I should use to complete this install?
By Chris C. on January 27, 2015
With a rear vented stove installed into an existing fireplace, a liner could be connected to a tee
directly on the back of the stove. A section of the Ventinox 4 Inch x 7.7 Inch Oval Liner
could then be connected to the tee, then passed through this sealing kit to above the damper opening.
By Gary from Becket, MA on May 22, 2014
What are the dimensions? I need this info in order to determine if this item will fit the opening.
By eFireplaceStore on May 22, 2014
Answer:This kit measures 24 inches in length and 9 inches in width.